NEWS: Eachine Revenger 55 (70g, 10A BLheli_S/Dshot600, 1102/11500Kv)

The “Smaller and smaller 2017 microbrushless FPV machine will be” sentence is certainly one more time true with the introduction of the Eachine Revenger 55: https://www.banggood.com/Eachine-Revenger55-Micro-55mm-FPV-Racing-Drone-BNF-with-F3-6A-BLHeli_S-Dshot-600TVL-5_8G-48CH-VTX-p-1158377.html.

We have a 55mm machine, dimensions probably without the propguard, so something comparable to classic nanoquadcopter CX-20 !!!! Just incredible. In this tiny spaces, we have all mooden electronics: i) a F3 Omnibus board but seems to be without a builtin OSD 🙁 :(, ii) 4-in-1 10A BLheli_S/Dshot 600 ESC board and 1102/11500 KV motors, the same motors as for the DYS ELF 82mm for example. The FPV rig a clasic 600TVL CMOS camera coupled with a 25mW 48CH VTX. Four choices of receivers: i) FrSky D8 + RSSI channel ii) FrSky D16 Smarport, iii) FlySky AFHDS-2A and iv) Spektrum DSM2/DSMX. Some originality in the design: The FPV camera is installed below the main body… probably more exposed to crash here but at least no props occlusion in the FPV signal. The receiver is installed latteraly … The machine is powered by a 400mAh 2S LiPo. I don’t think the system can handle 3D setup. Announced to weight a little bit less than 70g so not super ultralight as we could expected from it size. 3 little minutes are announced 🙁 🙁 ….I asked to review one and I should 🙂

null

null

The camera can be uptilted

null

JST connector

null

null

null

null

null

null

null

null

Specification:
Brand name: Eachine
Model: Revenger55
Item name: Eachine Revenger55 Micro 55mm FPV Racing Drone
Wheelbase: 55mm
Size: 82mm*82mm*37mm
Weight: about 49.5g (battery not include)
Take off weight: about 69.1g
Flight controller: F3 Flight controller
Motor: Eachine 1102 KV11500 brushless motor
Propeller: 38.1mm 4-blades propeller
Camera: 600TVL HD CMOS 1/4inch
VTX: 5.8g 25MW 48CH NTSC/PAL Video transmitter
Battery: 7.4V 400mah 40C lipo battery
Firmware of Flight controller: Betaflight 3.1
Flight time: 3minutes
Buzzer Ready

BNF Receiver Option:
– Original Frsky XSR-E receiver (Smartport ready)
– Compatible Frsky SBUS D8 mode receiver (RSSI Output)
– Compatible Flysky 8ch AFHDS2A receiver
– Compatible Specktrum DSM2/DSMX Compatible receiver

Flight controller Specification:
Size: 20mm*20mm*4mm
Mount hole: 15mm*15mm
Processor: STM32 F303 MCU
Sensor: SPI Sensor MPU6000
Firmware version: Betaflight 3.1 Dshot ready
Target: OmnibusF3

ESC specification:
6A BLHeli_S Dshot 2 In 1 ESC
Size: 20mm*20mm*4mm
Mount hole: 15mm*15mm
Firmware version: BLHELI_S 16.5
BB2, 48MHZ Chip
Lipo Battery: 2S
Con. Current: 6A
Peak Current: 10A (10S)
Programming: YES
Betaflight passtrough ready
Dshot600 ready(Default)
Support oneshot42, oneshot125, Multishot and Dshot 150/300/600
Damped light on

Features:
-Extremely light and more powerful
-STM32 F303MCU + BLHELI_S ESC make your Operating feel more stabilly and silky
-Adjustable Angle of Camera
-Jaw-dropping flight performance
-Betaflight support
-Acro mode/Air mode/Angle mode support
-BLEHELI_S pass-through ready

Package included:
1* Eachine Revenger55 micro 55mm frame kit
1* Frsky D8 reciever/Frsky D16 reciever/Flysky 8ch AFHDS2A receiver/DSM2/DSMX receiver (option)
1* F3 flight controller
1* 6A BLHeli_S Dshot 2 In 1 ESC
4* Eachine 1102 KV11500 brushless motor
4* 38.1mm 4-blades propeller
1* 600TVL camera
1* 5.8g 25MW 48CH NTSC/PAL Video transmitter
1* battery

1 Comment

Leave a Comment