NEWS: ImmersionRC Powermeter V2.0

Any advanced RCmodelist should have a powermeter. And ImmersionRC will introduce the version V2:
This kind of tool is able to measure directly the output of a VTX working in large range of carrier and not only reserved for the 5.8Ghz band. More, if you plug the provided 2dBi antenna, you can measure wireless the received signal and if you move the powermeter around the source, you can even draw a radiation diagram. With the V2, now the 30dB attenuator is internal (good point). Thanks to it, you can plug via the RP-SMA any input from -20dBm (1mW) up to 30dBM (1000mW). More there is an internal LiPo for a 8h non-stop usage. A small OLED 128×64 display is here. The V2 adds a PowerScope mode where data packets are display in time domain. In can be very usefull to check the correct behaviour of a transmission.






Power Level: -20dBm up to +30dBm
Calibrated Frequencies: 35, 72, 433, 1200, 2400, 5600-6000MHz in 50MHz steps
Accuracy: +/- 0.5dB
Attenuator: 30dB (Internal)
Battery: 3.7V Lithium Ion cell, 10440 size, 600mAh
Current Consumption: ~35mA
Battery Life: ~8 hours
Auto Shutdown: 5 minute timeout
Charging: Micro USB cable
Display: OLED, 128×64 pixels, monochrome
User Input: Joystick
Interfaces: USB, power control via CDC
Antenna: 5.8GHz ‘Sniffer Antenna’ (linearly polarized ~2dBi dipole)
Adapter: Male to Male SMA adapter

Package included:
1 x Power meter
1 x SMA M-M adapter
1 x 5.8G dipole

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.